Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM E643-84(1995)

Standard Test Method for Ball Punch Deformation of Metallic Sheet Material

Standard Test Method for Ball Punch Deformation of Metallic Sheet Material E0643-84R95 ASTM|E0643-84R95|en-US Standard Test Method for Ball Punch Deformation of Metallic Sheet Material Standard new BOS Vol. 03.01 Committee E28
$ 66.00 In stock

Scope

1.1 This test method covers the procedure for conducting the ball punch deformation test for metallic sheet materials intended for forming applications. The test applies to specimens with thicknesses between 0.008 and 0.080 in. (0.20 and 2.00 mm).

1.2 The values stated in inch-pound units are to be regarded as the standard.

Note 1--The ball punch deformation test is intended to replace the Olsen cup test by standardizing many of the test parameters that previously have been left to the discretion of the testing laboratory.

Note 2--The modified Erichsen test has been standardized in Europe. The main differences between the ball punch deformation test and the Erichsen test are the diameters of the penetrator and the dies. Erichsen cup heights are given in SI units.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 03.01
Developed by Subcommittee: E28.02
Pages: 4
DOI: 10.1520/E0643-84R95