Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM E110-82(2002)

Standard Test Method for Indentation Hardness of Metallic Materials by Portable Hardness Testers

Standard Test Method for Indentation Hardness of Metallic Materials by Portable Hardness Testers E0110-82R02 ASTM|E0110-82R02|en-US Standard Test Method for Indentation Hardness of Metallic Materials by Portable Hardness Testers Standard new BOS Vol. 03.01 Committee E28
$ 66.00 In stock

Abstract

This test method establishes the standard procedures, including the calibration, precision and bias of the apparatus used, for the determination of indentation hardness of metallic materials by means of portable hardness testers.

Scope

1.1 This test method covers determination of the indentation hardness of metallic materials by means of portable hardness testers.

1.2 This test method applies only to those portable hardness testers which apply the same nominal loads and use the same indenters as are used in the methods listed in Section 2.

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 03.01
Developed by Subcommittee: E28.06
Pages: 2
DOI: 10.1520/E0110-82R02
ICS Code: 77.040.10