ASTM D888-05

    Standard Test Methods for Dissolved Oxygen in Water

    SUPERSEDED (see Active link, below)


      Format Pages Price  
    PDF 11 $57.60   ADD TO CART


    1. Scope

    1.1 These test methods cover the determination of dissolved oxygen in water. Three test methods are given as follows:

    Range, mg/LSections
    Test Method A-Titrimetric Procedure-High Level>1.08 to 15
    Test Method B-Instrumental Probe Procedure0.05 to 2016 to 25
    Test Method C-Luminescence-based Sensor0.05 to 2026 to 29

    1.2 The precision of Test Methods A and B was carried out using a saturated sample of reagent water. It is the user's responsibility to ensure the validity of the test methods for waters of untested matrices.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific precautionary statement, see Note 17.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1066 Practice for Sampling Steam

    D1129 Terminology Relating to Water

    D1193 Specification for Reagent Water

    D2777 Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water

    D3370 Practices for Sampling Water from Closed Conduits

    D5847 Practice for Writing Quality Control Specifications for Standard Test Methods for Water Analysis

    E200 Practice for Preparation, Standardization, and Storage of Standard and Reagent Solutions for Chemical Analysis


    ICS Code

    ICS Number Code 13.060.50 (Examination of water for chemical substances)

    UNSPSC Code

    UNSPSC Code


    DOI: 10.1520/D0888-05

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top