Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM D6478-08

Standard Test Method for Determining Specific Packability of Fabrics Used in Inflatable Restraints

Standard Test Method for Determining Specific Packability of Fabrics Used in Inflatable Restraints D6478-08 ASTM|D6478-08|en-US Standard Test Method for Determining Specific Packability of Fabrics Used in Inflatable Restraints Standard new BOS Vol. 07.02 Committee D13
$ 75.00 In stock

Significance and Use

This test method is useful for determining the specific packability of uncoated and coated airbag fabrics. Fabric packability is an important factor in the design of airbag modules due to their inherent spacial contraints.

A folded specimen exhibits better specific packability if it occupies a lower total volume at the specified loads compared to another specimen.

The time required to test one sample (four specimens from the same lot of fabric) is approximately 1.5 h using this test method. Due to the length of time required by this test method to perform a single test, this test method is most suitable for use in design and development analysis or for inclusion in a list of required tests conducted for annual certification of an airbag fabric.

Scope

1.1 This test method covers procedures for determining the ability to fold and pack fabrics used for inflatable restraints using an index of specific packability.

1.2 Procedures in this test method describe operator techniques that must be followed closely to obtain repeatable and accurate results. Since these techniques are difficult to convey in writing, supplemental training for operators is required. A training video is available from ASTM (see Adjuncts ADJD6478 and ADJD6478A and ).

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system must be used independent of the other.

1.4 Procedures and apparatus other than those stated in this practice may be used as agreed upon between the purchaser and the supplier with specific deviations from this practice acknowledged in the report.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 07.02
Developed by Subcommittee: D13.20
Pages: 5
DOI: 10.1520/D6478-08
ICS Code: 43.040.60; 59.080.30