1. Scope
1.1 This practice covers the fabrication and closure of new, 1100-unit, triple-wall corrugated fiberboard containers.
1.2 This practice indicates the factors and components that must be controlled in the manufacture of triple-wall fiberboard containers.
1.3 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
D996 Terminology of Packaging and Distribution Environments
D3950 Specification for Strapping, Nonmetallic (and Joining Methods)
D3951 Practice for Commercial Packaging
D3953 Specification for Strapping, Flat Steel and Seals
D4675 Guide for Selection and Use of Flat Strapping Materials
D4727/D4727M Specification for Corrugated and Solid Fiberboard Sheet Stock (Container Grade) and Cut Shapes
D5330/D5330M Specification for Pressure-Sensitive Tape for Packaging, Filament-Reinforced
D5486/D5486M Specification for Pressure-Sensitive Tape for Packaging, Box Closure, and Sealing
SI10 American National Standard for Use of the International System of Units (SI): The Modern Metric System
TAPPI Standards
T812 Ply Separation of Solid and Corrugated Fiberboard (Wet)
Code of Federal Regulations
CFRParts107-180Title Hazardous Materials Regulations
Other Standards
Uniform Freight Classification
Use of Other Specifications
2.5.2 Exceptional commodities may require better containers than are specified herein. Containers for explosives and dangerous articles shall comply with the specifications prescribed in the Department of Transportations (DOT) Office of Hazardous Materials Code of Federal Regulations, Title 49 CFR Parts 107-180. In addition, for the particular articles to which these regulations apply, if the requirements contained in this practice are more stringent, then they must also meet the requirements specified herein. (The DOT regulations apply to such articles as explosives, flammable liquids and solids, compressed gases, oxidizing materials, poisons, and so forth).
Index Terms
corrugated; fiberboard; performance; short column crush test; triple wall; Corrugated board/fiberboard materials/applications; Fabricated materials; Fiberboard containers; Performance--containers/packaging/shipping; Short column crush test; Triple wall corrugated fiberboard containers; Closure
DOI: 10.1520/D5168-98
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
