Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM D4001-93(1999)

Standard Test Method for Determination of Weight-Average Molecular Weight of Polymers By Light Scattering

Standard Test Method for Determination of Weight-Average Molecular Weight of Polymers By Light Scattering D4001-93R99 ASTM|D4001-93R99|en-US Standard Test Method for Determination of Weight-Average Molecular Weight of Polymers By Light Scattering Standard new BOS Vol. 08.02 Committee D20
$ 83.00 In stock

Scope

1.1 This test method describes the test procedures for determining the weight-average molecular weight Mw of polymers by light scattering. It is applicable to all nonionic homopolymers (linear or branched) that dissolve completely without reaction or degradation to form stable solutions. Copolymers and polyelectrolytes are not within its scope. The procedure also allows the determination of the second virial coefficient, A2, which is a measure of polymer-solvent interactions, and the root-mean-square radius of gyration (s ) 1/2 , which is a measure of the dimensions of the polymer chain.

1.2 The molecular-weight range for light scattering is, to some extent, determined by the size of the dissolved polymer molecules and the refractive indices of solvent and polymer. A range frequently stated is 10 000 to 10 000 000, but this may be extended in either direction with suitable systems and by the use of special techniques.

1.2.1 The lower limit to molecular weight results from low levels of excess solution scattering over that of the solvent. The greater the specific refractive increment dn/dc (difference in refractive indices of solution and solvent per unit concentration), the greater the level of solution scattering and the lower the molecular weight that can be determined with a given precision.

1.2.2 The upper limit to molecular weight results from the angular dependence of the solution scattering, which is determined by the molecular size. For sufficiently large molecules, measurements must be made at small scattering angles, which are ultimately outside the range of the photometer used.

1.3 The values stated in SI units are to be regarded as the standard.

1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use .

Note 1-There are no similar or equivalent ISO standards.
Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 08.02
Developed by Subcommittee: D20.70
Pages: 12
DOI: 10.1520/D4001-93R99
ICS Code: 83.080.01