Standard Historical Last Updated: Nov 07, 2011 Track Document
ASTM D3811/D3811M-96(2006)

Standard Test Method for Unwind Force of Pressure-Sensitive Tapes

Standard Test Method for Unwind Force of Pressure-Sensitive Tapes D3811_D3811M-96R06 ASTM|D3811_D3811M-96R06|en-US Standard Test Method for Unwind Force of Pressure-Sensitive Tapes Standard new BOS Vol. 15.10 Committee D10
$ 66.00 In stock

Significance and Use

This procedure simulates hand and machine unwinding of tape at low rates. The force required for unwinding at low rates is a function of rate. At some rate (expected to be different for each construction type and manufacturer) there occurs an inversion of the response. The rate for this test method does not allow for comparisons of different tapes that will be unwound at high rates.

This procedure can be used to indicate satisfaction where a specification for unwind, either maximum or minimum, is established and when the responses referred to in 5.1 are taken into consideration.

Scope

1.1 This test method provides one procedure for determining the force required to unwind a roll of pressure-sensitive tape.

1.2 The values stated in either SI or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently, without combining values in any way.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 15.10
Developed by Subcommittee: D10.14
Pages: 2
DOI: 10.1520/D3811_D3811M-96R06
ICS Code: 55.040