Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM D3667-85(2000)

Standard Specification for Rubber Seals Used in Flat-Plate Solar Collectors

Standard Specification for Rubber Seals Used in Flat-Plate Solar Collectors D3667-85R00 ASTM|D3667-85R00|en-US Standard Specification for Rubber Seals Used in Flat-Plate Solar Collectors Standard new BOS Vol. 09.02 Committee D11
$ 66.00 In stock

Scope

1.1 This specification covers the general requirements for materials used in rubber seals of flat-plate solar collectors, except vertically mounted passive collectors. Particular applications may necessitate other requirements that would take precedence over these requirements when specified.

1.2 The design requirement pertains only to permissible deflections of the rubber during thermal expansion or contraction of the seal in use and the tolerances in dimensions of molded and extruded seals.

1.3 This specification does not include requirements pertaining to the fabrication or installation of the seals.

1.4 The values stated in SI units are to be regarded as the standard.

1.5 The following safety hazards caveat pertains only to the test methods portion, Section 9, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 09.02
Developed by Subcommittee: D11.37
Pages: 3
DOI: 10.1520/D3667-85R00
ICS Code: 21.140