Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM D3123-98(1999)e1

Standard Test Method for Spiral Flow of Low-Pressure Thermosetting Molding Compounds

Standard Test Method for Spiral Flow of Low-Pressure Thermosetting Molding Compounds D3123-98R99E01 ASTM|D3123-98R99E01|en-US Standard Test Method for Spiral Flow of Low-Pressure Thermosetting Molding Compounds Standard new BOS Vol. 08.01 Committee D20
$ 66.00 In stock

Scope

1.1 This test method covers a procedure for measuring the spiral flow of thermosetting molding compounds (soft or very soft) designed for molding pressures under 6.9 MPa (1000 psi). It is especially suited for those compounds that may be used for encapsulation or other low pressure molding techniques. Textile-reinforced compounds should not be tested using this test method. It involves the use of a standard spiral flow mold in a transfer molding press under specified conditions of applied temperature and pressure with a controlled charge mass.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1-There is no equivalent ISO standard.
Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 08.01
Developed by Subcommittee: D20.30
Pages: 3
DOI: 10.1520/D3123-98R99E01
ICS Code: 83.140.99