ASTM D25-99(2005)

    Standard Specification for Round Timber Piles

    SUPERSEDED (see Active link, below)


      Format Pages Price  
    PDF 7 $50.40   ADD TO CART


    1. Scope

    1.1 This specification covers the physical characteristics of unused round timber piles to be used either treated or untreated.

    1.2 This specification is not intended for preused piles unless the piles have the quality specified by this specification and design stresses equal to or greater than those derived from Method D 2899.

    1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.4 his standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D9 Terminology Relating to Wood and Wood-Based Products

    D2555 Practice for Establishing Clear Wood Strength Values

    D2899 Practice for Establishing Allowable Stresses for Round Timber Piles


    ICS Code

    ICS Number Code 79.080 (Semi-manufactures of timber)

    UNSPSC Code

    UNSPSC Code 30103600(Structural products)


    DOI: 10.1520/D0025-99R05

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top