Standard Historical Last Updated: Aug 16, 2017 Track Document
ASTM D2068-97(2003)

Standard Test Method for Filter Blocking Tendency of Distillate Fuel Oils

Standard Test Method for Filter Blocking Tendency of Distillate Fuel Oils D2068-97R03 ASTM|D2068-97R03|en-US Standard Test Method for Filter Blocking Tendency of Distillate Fuel Oils Standard new BOS Vol. 05.01 Committee D02
$ 75.00 In stock

Scope

1.1 This test method describes a procedure for determining the filter plugging tendency (FPT) of distillate fuel oils where the end use demands an exceptional degree of cleanliness. This test method is applicable to fuels within the viscosity range of 1.50 to 6.00 mm2/s (cSt) at 40°C.

Note 1—ASTM Specification fuels falling within the scope of this test method are Specification D 396 Grade Numbers 1 and 2, Specification D 975 Grades 1-D, low sulfur 1-D, 2-D, and low sulfur 2-D, Specification D 2880 Grades 1-GT and 2-GT and Specification D 3699 kerosine.

1.2 This test method is not applicable to fuels that are not clear and bright because water interferes with the measurement of filter plugging.

1.3 Relative tendency of fuels to plug filters may vary depending on filter porosity and structure, and may not always correlate with results from this test method.

1.4 Annex A1 describes a standard procedure for preparing a test fluid for use in calibrating the apparatus used in this test method.

1.5 &si-value;

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 05.01
Developed by Subcommittee: D02.14
Pages: 5
DOI: 10.1520/D2068-97R03
ICS Code: 75.160.20