ASTM D1933-03

    Standard Specification for Nitrogen Gas as an Electrical Insulating Material

    SUPERSEDED (see Active link, below)


      Format Pages Price  
    PDF 2 $45.60   ADD TO CART


    1. Scope

    1.1 This specification covers three types of nitrogen used as an electrical insulating material in electrical equipment:

    1.1.1 Type I obtained from the air by liquefaction processes and dried,

    1.1.2 Type II obtained from the air by liquefaction processes, deoxidized with hydrogen over a platinum catalyst, and dried, and

    1.1.3 Type III obtained from the air by liquefaction processes and if necessary deoxidized by suitable means.

    Note 1—The fact that metal containers are filled with materials meeting this specification does not exclude the possibility that the materials might become contaminated with unlisted impurities.

    1.2 The following safety hazards caveat pertains only to the test method portion, Section 5, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D2029 Test Methods for Water Vapor Content of Electrical Insulating Gases by Measurement of Dew Point

    E105 Practice for Probability Sampling of Materials

    E260 Practice for Packed Column Gas Chromatography


    ICS Code

    ICS Number Code 29.040.20 (Insulating gases)

    UNSPSC Code

    UNSPSC Code 12141903(Nitrogen N)


    DOI: 10.1520/D1933-03

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top