ASTM D1316-06

    Standard Test Method for Fineness of Grind of Printing Inks By the NPIRI Grindometer


      Format Pages Price  
    PDF 7 $51.60   ADD TO CART


    1. Scope

    1.1 This test method describes the procedure for determining the fineness of grind of printing inks using a NPIRI Grindometer. It evaluates the size of the largest particles in a finished dispersion but not average particle size or concentration of sizes.

    1.2 This test method covers both manual and automatic drawdowns using an A1 scraper.

    1.3 This test method is applicable to any dispersion that is fine enough to fall within the 0-25 m range of the specified grind gauge. With a minor variation in procedure, it is applicable to both paste (nonvolatile) and liquid (volatile) inks.

    Note 1—The 0-25 m gauge specified in this test method is similar in principle to the 0-100 m Hegman gauge described in Test Method D 1210 and the various gauges described in ISO 1524:2000. Sieve analysis for concentration of particles above 45 m is covered in Test Method D 2067.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    D1210 Test Method for Fineness of Dispersion of Pigment-Vehicle Systems by Hegman-Type Gage

    D2067 Test Method for Coarse Particles in Printing Ink Dispersions

    D6846 Practice for Preparing Prints of Paste Printing Inks with a Printing Gage

    E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods

    E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method

    ISO Standards

    ISO1524:2000 Paints, varnishes and printing inks -- Determination of fineness of grind


    ICS Code

    ICS Number Code 87.080 (Inks. Printing inks)

    UNSPSC Code

    UNSPSC Code 45101700(Printing accessories)


    Referencing This Standard

    DOI: 10.1520/D1316-06

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM D1316-06, Standard Test Method for Fineness of Grind of Printing Inks By the NPIRI Grindometer, ASTM International, West Conshohocken, PA, 2006, www.astm.org

    Back to Top