Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM C989-09

Standard Specification for Slag Cement for Use in Concrete and Mortars

Standard Specification for Slag Cement for Use in Concrete and Mortars C0989-09 ASTM|C0989-09|en-US Standard Specification for Slag Cement for Use in Concrete and Mortars Standard new BOS Vol. 04.02 Committee C09
$ 75.00 In stock

Abstract

This specification covers three strength grades of finely ground granulated blast-furnace slag (Grades 80, 100, and 120) for use as a cementitious material in concrete and mortars. The slag shall contain no additions and shall conform to the sulfide sulfur and sulfate chemical composition requirement. Physical properties of the slag shall be in accordance with the requirements for fineness as determined by air permeability and air content, slag activity index, and compressive strength.

Scope

1.1 This specification covers three strength grades of slag cement for use as a cementitious material in concrete and mortar.

Note 1—The material described in this specification may be used for blending with portland cement to produce a cement meeting the requirements of Specification C 595 or as a separate ingredient in concrete or mortar mixtures. The material may also be useful in a variety of special grouts and mortars, and when used with an appropriate activator, as the principal cementitious material in some applications.

Note 2—Information on technical aspects of the use of the material described in this specification is contained in Appendix X1, Appendix X2, and Appendix X3. More detailed information on that subject is contained in ACI 233R-03, formerly ACI 226.1R.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 The following safety hazards caveat pertains only to the test methods described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 The text of this standard references notes and footnotes that provide explanatory information. These notes and footnotes (excluding those in tables) shall not be considered as requirements of this standard.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.02
Developed by Subcommittee: C09.27
Pages: 6
DOI: 10.1520/C0989-09
ICS Code: 91.100.30