ASTM C836-00

    Historical Standard: ASTM C836-00 Standard Specification for High Solids Content, Cold Liquid-Applied Elastomeric Waterproofing Membrane for Use with Separate Wearing Course

    SUPERSEDED (see Active link, below)


    Buy Standard (PDF)
    4 pages
    $44.40

    Active (view current version of standard)


    1. Scope

    1.1 This specification describes the required properties and test methods for a cold liquid-applied elastomeric-type membrane, one or two component, for waterproofing building decks subject to hydrostatic pressure in building areas to be occupied by personnel, vehicles, or equipment. This specification applies only to a membrane system above which a separate wearing or traffic course will be applied.

    Note 1--See Guide C898 for proper application of membrane.

    1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

    1.3 The following safety hazards caveat pertains only to the test method portion, Section 6, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    1.4 There are no ISO standards similar or equivalent to this ASTM standard.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    C717 Terminology of Building Seals and Sealants

    C794 Test Method for Adhesion-in-Peel of Elastomeric Joint Sealants

    C898 Guide for Use of High Solids Content, Cold Liquid-Applied Elastomeric Waterproofing Membrane with Separate Wearing Course

    C1250 Test Method for Nonvolatile Content of Cold Liquid-Applied Elastomeric Waterproofing Membranes

    C1305 Test Method for Crack Bridging Ability of Liquid-Applied Waterproofing Membrane

    C1375 Guide for Substrates Used in Testing Building Seals and Sealants

    C1471 Guide for the Use of High Solids Content Cold Liquid-Applied Elastomeric Waterproofing Membrane on Vertical Surfaces

    C1522 Test Method for Extensibility After Heat Aging of Cold Liquid-Applied Elastomeric Waterproofing Membranes

    D2240 Test Method for Rubber Property--Durometer Hardness


    ICS Code

    ICS Number Code 91.100.50 (Binders. Sealing materials)

    UNSPSC Code

    UNSPSC Code 30151505(Roofing membranes); 13101700(Elastomers)


    DOI: 10.1520/C0836-00

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top