Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM C1435/C1435M-06

Standard Practice for Molding Roller-Compacted Concrete in Cylinder Molds Using a Vibrating Hammer

Standard Practice for Molding Roller-Compacted Concrete in Cylinder Molds Using a Vibrating Hammer C1435_C1435M-06 ASTM|C1435_C1435M-06|en-US Standard Practice for Molding Roller-Compacted Concrete in Cylinder Molds Using a Vibrating Hammer Standard new BOS Vol. 04.02 Committee C09
$ 66.00 In stock

Significance and Use

This practice, intended for use in testing roller-compacted concrete, may be applicable to testing other types of cementitious material such as coarse-grained, soil-cement. This practice provides standardized requirements for molding stiff to very dry consistency concrete mixtures commonly used in roller compacted concrete construction. This practice is used instead of rodding or internal vibration, which cannot properly consolidate concrete of this consistency (Note 1).

Note 1—Further description of roller compacted concrete consistency is given in ACI 207.5R and 211.3. The consistency of concrete using a vibrating table may be determined in accordance with Test Methods C 1170.

This practice is used to mold cylindrical test specimens commonly used for testing compressive or tensile strength of concrete. Specimens tested for compressive strength and splitting tensile strength shall be in accordance with Test Methods C 39/C 39M and C 496/C 496M, respectively. Test specimens also may be used to determine density of fresh concrete. Specimens tested for density of fresh concrete shall be in accordance with Test Methods C 1170.

Note 2—For some extremely dry mixtures; (those with a consistency greater than 45 s when tested in accordance with Test Methods C 1170)4 the density of specimens made in accordance with this practice may be greater than the in-place density of roller-compacted concrete due to the greater potential for voids at the bottom of the lifts in the field.

Scope

1.1 This practice covers molding cylindrical test specimens from concrete when the standard procedures of rodding and internal vibration, as described in Practice C 31/C 31M and Practice C 1176, are not practicable. This practice is applicable to freshly-mixed concrete, prepared in the laboratory and the field.

1.2 Freshly-mixed concrete is molded in cylindrical molds using an electric vibrating hammer equipped with a shaft and circular plate.

1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the inch-pound units are shown in brackets. The values stated in each system may not be exact equivalents, therefore, each system must be used independently of each other without combining in any way.

1.4 The text of this practice references notes and footnotes, which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this practice.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.02
Developed by Subcommittee: C09.45
Pages: 4
DOI: 10.1520/C1435_C1435M-06
ICS Code: 91.100.30