Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM C133-97(2003)

Standard Test Methods for Cold Crushing Strength and Modulus of Rupture of Refractories

Standard Test Methods for Cold Crushing Strength and Modulus of Rupture of Refractories C0133-97R03 ASTM|C0133-97R03|en-US Standard Test Methods for Cold Crushing Strength and Modulus of Rupture of Refractories Standard new BOS Vol. 15.01 Committee C08
$ 75.00 In stock

Significance and Use

The cold strength of a refractory material is an indication of its suitability for use in refractory construction. (It is not a measure of performance at elevated temperatures.)

These test methods are for determining the room temperature flexural strength in 3-point bending (cold modulus of rupture) or compressive strength (cold crushing strength), or both, for all refractory products.

Considerable care must be used to compare the results of different determinations of the cold crushing strength or modulus of rupture. The specimen size and shape, the nature of the specimen faces (that is, as-formed, sawed, or ground), the orientation of those faces during testing, the loading geometry, and the rate of load application, may all significantly affect the numerical results obtained. Comparisons of the results between different determinations should not be made if one or more of these parameters differ between the two determinations.

The relative ratio of the largest grain size to the smallest specimen dimension may significantly affect the numerical results. For example, smaller, cut specimens containing large grains may present different results than the bricks from which they were cut. Under no circumstances should 6- by 1- by 1-in. (152- by 25- by 25-mm) specimens be prepared and tested for materials containing grains with a maximum grain dimension exceeding 0.25 in. (6.4 mm).

This test method is useful for research and development, engineering application and design, manufacturing process control, and for developing purchasing specifications.

Scope

1.1 These test methods cover the determination of the cold crushing strength and the modulus of rupture (MOR) of dried or fired refractory shapes of all types.

1.2 The test methods appear in the following sections:

Test Method Sections
Cold Crushing Strength4 to 9
Modulus of Rupture10 to 15

1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 15.01
Developed by Subcommittee: C08.01
Pages: 6
DOI: 10.1520/C0133-97R03
ICS Code: 81.080