SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|9||$52.80||  ADD TO CART|
1.1 This test method covers procedures for masonry prism construction and testing, and procedures for determining the compressive strength of masonry, f'mt', used to determine compliance with the specified compressive strength of masonry, f `m'. When this test method is used for research purposes, the construction and test procedures within serve as a guideline and provide control parameters.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
C67 Test Methods for Sampling and Testing Brick and Structural Clay Tile
C136 Test Method for Sieve Analysis of Fine and Coarse Aggregates
C140 Test Methods for Sampling and Testing Concrete Masonry Units and Related Units
C143/C143M Test Method for Slump of Hydraulic-Cement Concrete
C144 Specification for Aggregate for Masonry Mortar
C270 Specification for Mortar for Unit Masonry
C476 Specification for Grout for Masonry
C780 Test Method for Preconstruction and Construction Evaluation of Mortars for Plain and Reinforced Unit Masonry
C1019 Test Method for Sampling and Testing Grout
C1093 Practice for Accreditation of Testing Agencies for Masonry
C1532 Practice for Selection, Removal, and Shipment of Manufactured Masonry Units and Masonry Specimens from Existing Construction
C1552 Practice for Capping Concrete Masonry Units, Related Units and Masonry Prisms for Compression Testing
C1587 Practice for Preparation of Field Removed Manufactured Masonry Units and Masonry Specimens for Testing
E105 Practice for Probability Sampling of Materials
E111 Test Method for Youngs Modulus, Tangent Modulus, and Chord Modulus
ICS Number Code 19.060 (Mechanical testing); 91.080.30 (Masonry)
ASTM C1314-03b, Standard Test Method for Compressive Strength of Masonry Prisms, ASTM International, West Conshohocken, PA, 2003, www.astm.orgBack to Top