Standard Historical Last Updated: Mar 19, 2012 Track Document
ASTM C1313/C1313M-11

Standard Specification for Sheet Radiant Barriers for Building Construction Applications

Standard Specification for Sheet Radiant Barriers for Building Construction Applications C1313_C1313M-11 ASTM|C1313_C1313M-11|en-US Standard Specification for Sheet Radiant Barriers for Building Construction Applications Standard new BOS Vol. 04.06 Committee C16
$ 66.00 In stock

Significance and Use

This specification recognizes that the effectiveness of a sheet radiant barrier is dependent on proper installation. Practice C1158 addresses use and installation of radiant barriers.

This specification identifies the material properties that are important for sheet radiant barrier products. When appropriate, values for the properties have been stated.

The user should consult the manufacturer about specific material properties are needed for a particular application.

Radiant barriers shall be free of dust or other contaminants to remain effective.

Abstract

This specification covers the general physical property requirements of radiant barrier materials for use in building construction. The scope is specifically limited to requirements for radiant barrier sheet materials that consist of at least one surface, such as metallic foils or metallic deposits mounted or unmounted on substrates. Sheet radiant barrier materials shall consist of low emittance surface(s) that may be in combination with any substrates and adhesives required to meet the specified physical material properties. The following test methods shall be performed: surface emittance; water vapor transmission; surface burning characteristics; corrosivity; tear resistance; and adhesive performance.

Scope

1.1 This specification covers the general physical property requirements of radiant barrier materials for use in building construction. The scope is specifically limited to requirements for radiant barrier sheet materials that consist of at least one surface having a far-infrared emittance of 0.1 or less, such as metallic foils or metallic deposits mounted or unmounted on substrates.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 The following safety hazards caveat pertains only to the test methods (Section 10) described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 04.06
Developed by Subcommittee: C16.21
Pages: 3
DOI: 10.1520/C1313_C1313M-11
ICS Code: 91.120.10