ASTM C1107/C1107M-11

    Standard Specification for Packaged Dry, Hydraulic-Cement Grout (Nonshrink)

    SUPERSEDED (see Active link, below)


      Format Pages Price  
    PDF Version 5 $50.40   ADD TO CART


    1. Scope

    1.1 This specification covers packaged dry, hydraulic cement grout (nonshrink) intended for use under applied load (such as to support a structure, a machine, and the like) where a change in height below initial placement height is to be avoided.

    1.2 Grouts covered are composed of hydraulic cement, fine aggregate, and other ingredients. They require only the addition of mixing water for use.

    1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

    1.4 The following safety hazards caveat pertains only to the test method portion of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    C109/C109M Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 2-in. or [50-mm] Cube Specimens)

    C125 Terminology Relating to Concrete and Concrete Aggregates

    C138/C138M Test Method for Density (Unit Weight), Yield, and Air Content (Gravimetric) of Concrete

    C157/C157M Test Method for Length Change of Hardened Hydraulic-Cement Mortar and Concrete

    C185 Test Method for Air Content of Hydraulic Cement Mortar

    C305 Practice for Mechanical Mixing of Hydraulic Cement Pastes and Mortars of Plastic Consistency

    C702 Practice for Reducing Samples of Aggregate to Testing Size

    C827 Test Method for Change in Height at Early Ages of Cylindrical Specimens of Cementitious Mixtures

    C939 Test Method for Flow of Grout for Preplaced-Aggregate Concrete (Flow Cone Method)

    C1090 Test Method for Measuring Changes in Height of Cylindrical Specimens of Hydraulic-Cement Grout

    C1437 Test Method for Flow of Hydraulic Cement Mortar


    ICS Code

    ICS Number Code 91.100.10 (Cement. Gypsum. Lime. Mortar)

    UNSPSC Code

    UNSPSC Code 30111506(Grout)


    DOI: 10.1520/C1107_C1107M-11

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top