ASTM C1007-04

    Standard Specification for Installation of Load Bearing (Transverse and Axial) Steel Studs and Related Accessories

      Format Pages Price  
    PDF 4 $48.00   ADD TO CART

    1. Scope

    1.1 This specification covers the installation and erection requirements for load bearing (transverse and axial) steel studs and related accessories 0.0329 in. (0.836 mm) to 0.1120 in. (2.845 mm) thick.

    1.2 Values stated in inch-pound units are to be regarded as the standard. The SI (metric) values given in parentheses are approximate and are provided for information purposes only.

    1.3 The text of this standard references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    C11 Terminology Relating to Gypsum and Related Building Materials and Systems

    C841 Specification for Installation of Interior Lathing and Furring

    C954 Specification for Steel Drill Screws for the Application of Gypsum Panel Products or Metal Plaster Bases to Steel Studs from 0.033 in. (0.84 mm) to 0.112 in. (2.84 mm) in Thickness

    C955 Specification for Load-Bearing (Transverse and Axial) Steel Studs, Runners (Tracks), and Bracing or Bridging for Screw Application of Gypsum Panel Products and Metal Plaster Bases

    C1063 Specification for Installation of Lathing and Furring to Receive Interior and Exterior Portland Cement-Based Plaster

    American Iron and Steel Institute Publication (AISI)

    S100 North American Specification for the Design of Cold-Formed Steel Structural Members - 2007 Edition Available from American Iron and Steel Institute (AISI), 1140 Connecticut Ave., NW, Suite 705, Washington, DC 20036,

    Military Specification

    MIL-P-21035 Paint, High Zinc Dust Content, Galvanizing Repair Available from Standardization Documents Order Desk, Bldg. 4 Section D, 700 Robbins Ave., Philadelphia, PA 19111-5094, Attn: NPODS.

    Federal Specification


    FF-P-395 Pin, Drive, Guided and Pin Drive, Power Actuated Fasteners for Power Actuated and Hand Actuated Fastening Tools

    ICS Code

    ICS Number Code 21.060.10 (Bolts, screws, studs)

    UNSPSC Code

    UNSPSC Code 31163300(Studs)

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/C1007-04

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM C1007-04, Standard Specification for Installation of Load Bearing (Transverse and Axial) Steel Studs and Related Accessories, ASTM International, West Conshohocken, PA, 2004,

    Back to Top