1.1 This specification establishes requirements for copper-silicon rod, bar, and shapes for UNS Alloys C65100, C65500, and C66100.
Note 1—Material for hot forging is covered by Specification B 124.
Note 2—For ASME Boiler and Pressure Vessel Code applications, see Specification SB-98 in Section II of that code.
1.2 The values stated in inch-pound units or SI units are to be regarded separately as standard. Within the text, SI units are shown in brackets. The values in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B124/B124M Specification for Copper and Copper Alloy Forging Rod, Bar, and Shapes
B249/B249M Specification for General Requirements for Wrought Copper and Copper-Alloy Rod, Bar, Shapes and Forgings
B601 Classification for Temper Designations for Copper and Copper Alloys--Wrought and Cast
E8 Test Methods for Tension Testing of Metallic Materials
E8M Test Methods for Tension Testing of Metallic Materials [Metric]
E18 Test Methods for Rockwell Hardness of Metallic Materials
E62 Test Methods for Chemical Analysis of Copper and Copper Alloys (Photometric Methods)
E478 Test Methods for Chemical Analysis of Copper Alloys
copper—rod, bar, shapes; copper-silicon alloy; high silicon bronze A; low silicon bronze B; silicon bronze; UNS No. C65100; UNS No. C65500; UNS No. C66100; Bronze rod/bar/shapes--specifications; Copper alloy rod/bar/shapes--specifications; Copper-silicon alloys; High silicon Bronze A; Low-silicon Bronze B; Silicon bronze--specifications; UNS C65100 (low silicon bronze B); UNS C65500 (high silicon bronze A); UNS C66100 (silicon bronze) ;
ICS Number Code 77.150.30 (Copper products)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]