Standard Historical Last Updated: Apr 21, 2016 Track Document
ASTM B968/B968M-10

Standard Test Method for Flattening of Copper and Copper-Alloy Pipe and Tube

Standard Test Method for Flattening of Copper and Copper-Alloy Pipe and Tube B0968_B0968M-10 ASTM|B0968_B0968M-10|en-US Standard Test Method for Flattening of Copper and Copper-Alloy Pipe and Tube Standard new BOS Vol. 02.01 Committee B05
$ 66.00 In stock

Significance and Use

When properly performed and interpreted, the flattening test will provide information about the relative ductility of a tube and presence of surface defects. For welded tube products, the test will provide information on the integrity of the weld seam.

In certain product specifications which establish requirements for tubes of sizes greater than 4 in. [100 mm], the test may be allowed as a substitute to the expansion pin test in B153.

Scope

1.1 This test method establishes the requirements for the flattening test for copper and copper alloy pipe and tube of all sizes. The method addresses both inch-pound and metric considerations, and both seamless and welded product.

1.2 UnitsValues stated in either inch-pound units or SI units are to be regarded as standard. Within the text, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 02.01
Developed by Subcommittee: B05.06
Pages: 3
DOI: 10.1520/B0968_B0968M-10
ICS Code: 77.150.30