SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|3||$46.80||  ADD TO CART|
1.1 This specification covers magnesium alloys in ingot form for remelting for the manufacture of sand castings, permanent mold castings, investment castings, and die castings.
Note 1—Supplementary information pertaining to the alloys covered by this specification when used in the form of castings is given in Specifications B80, B94, B199 and B403.
1.2 The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B80 Specification for Magnesium-Alloy Sand Castings
B94 Specification for Magnesium-Alloy Die Castings
B199 Specification for Magnesium-Alloy Permanent Mold Castings
B403 Specification for Magnesium-Alloy Investment Castings
B660 Practices for Packaging/Packing of Aluminum and Magnesium Products
B666 Practice for Identification Marking of Aluminum and Magnesium Products
B951 Practice for Codification of Unalloyed Magnesium and Magnesium-Alloys, Cast and Wrought
B953 Practice for Sampling Magnesium and Magnesium Alloys for Spectrochemical Analysis
B954 Test Method for Analysis of Magnesium and Magnesium Alloys by Atomic Emission Spectrometry
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
E35 Test Methods for Chemical Analysis of Magnesium and Magnesium Alloys
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
ICS Number Code 77.150.20 (Magnesium products)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM B93 / B93M-03, Standard Specification for Magnesium Alloys in Ingot Form for Sand Castings, Permanent Mold Castings, and Die Castings, ASTM International, West Conshohocken, PA, 2003, www.astm.orgBack to Top