ASTM B929-05

1. Scope

1.1 This specification establishes the requirements for copper-nickel-tin alloy rod and bar. The following alloy is included:

1.2 The following safety hazard caveat pertains only to the test method(s) described in this specification.

1.3 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

B249/B249M Specification for General Requirements for Wrought Copper and Copper-Alloy Rod, Bar, Shapes and Forgings

B846 Terminology for Copper and Copper Alloys

E8/E8M Test Methods for Tension Testing of Metallic Materials

E18 Test Methods for Rockwell Hardness of Metallic Materials

E53 Test Method for Determination of Copper in Unalloyed Copper by Gravimetry

E75 Test Methods for Chemical Analysis of Copper-Nickel and Copper-Nickel-Zinc Alloys

E478 Test Methods for Chemical Analysis of Copper Alloys

ICS Code

ICS Number Code 77.150.30 (Copper products)

DOI: 10.1520/B0929-05

ASTM International is a member of CrossRef.

Citing ASTM Standards

[Back to Top]