ASTM B90/B90M-98

    Standard Specification for Magnesium-Alloy Sheet and Plate


      Format Pages Price  
    PDF 5 $51.60   ADD TO CART


    1. Scope

    1.1 This specification covers magnesium alloys in sheet and plate form designated as shown in Table 1.

    1.2 The values stated in either inch-pound or SI units are to be regarded separately as standards. The SI units are shown in brackets or in separate tables or columns. The values stated in each system are not exact equivalents; therefore, each system must be used independent of the other. Combining values from the two systems may result in nonconformance with the specification.

    1.3 Unless the order specifies the "M" specification designation, the material shall be furnished to the inch-pound units.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B557 Test Methods for Tension Testing Wrought and Cast Aluminum- and Magnesium-Alloy Products

    B557M Test Methods for Tension Testing Wrought and Cast Aluminum- and Magnesium-Alloy Products (Metric)


    ICS Code

    ICS Number Code 77.150.20 (Magnesium products)

    UNSPSC Code

    UNSPSC Code 30261800(Magnesium bars and sheets)


    Referencing This Standard

    DOI: 10.1520/B0090_B0090M-98

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM B90 / B90M-98, Standard Specification for Magnesium-Alloy Sheet and Plate, ASTM International, West Conshohocken, PA, 1998, www.astm.org

    Back to Top