ASTM B86-10

    Standard Specification for Zinc and Zinc-Aluminum (ZA) Alloy Foundry and Die Castings


      Format Pages Price  
    PDF 8 $51.60   ADD TO CART


    1. Scope

    1.1 This specification covers commercial zinc, zinc-aluminum castings and continuous cast bar stock, as designated and specified in Table 1. Seven alloy compositions are specified and designated as follows:


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B557 Test Methods for Tension Testing Wrought and Cast Aluminum- and Magnesium-Alloy Products

    B899 Terminology Relating to Non-ferrous Metals and Alloys

    B949 Specification for General Requirements for Zinc and Zinc Alloy Products

    E88 Practice for Sampling Nonferrous Metals and Alloys in Cast Form for Determination of Chemical Composition

    E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)

    E536 Test Methods for Chemical Analysis of Zinc and Zinc Alloys

    E634 Practice for Sampling of Zinc and Zinc Alloys by Spark Atomic Emission Spectrometry

    Federal Standard

    Fed. Std. No. 123 Marking for Shipment (Civil Agencies)

    Military Standard

    MIL-STD-129 Marking for Shipment and Storage (Military Agencies)

    Military Specification

    MIL-P-116 Methods of Preservation


    UNSPSC Code

    UNSPSC Code 11101719(Zinc)


    Referencing This Standard

    DOI: 10.1520/B0086-10

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM B86-10, Standard Specification for Zinc and Zinc-Aluminum (ZA) Alloy Foundry and Die Castings, ASTM International, West Conshohocken, PA, 2010, www.astm.org

    Back to Top