1. Scope
1.1 This specification covers stainless steel powder metallurgy (P/M) structural components with a 7.7-g/cm3 minimum density that are fabricated from prealloyed powder consisting primarily of iron, chromium, nickel, molybdenum, and boron and are intended for use in corrosive service.
1.2 The values stated in inch-pound units are to be regarded as the standard. The SI values given in parentheses are for information only.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A262 Practices for Detecting Susceptibility to Intergranular Attack in Austenitic Stainless Steels
B117 Practice for Operating Salt Spray (Fog) Apparatus
B243 Terminology of Powder Metallurgy
B311 Test Method for Density of Powder Metallurgy (PM) Materials Containing Less Than Two Percent Porosity
E8 Test Methods for Tension Testing of Metallic Materials
E354 Test Methods for Chemical Analysis of High-Temperature, Electrical, Magnetic, and Other Similar Iron, Nickel, and Cobalt Alloys
E572 Test Method for Analysis of Stainless and Alloy Steels by X-ray Fluorescence Spectrometry
E1019 Test Methods for Determination of Carbon, Sulfur, Nitrogen, and Oxygen in Steel, Iron, Nickel, and Cobalt Alloys by Various Combustion and Fusion Techniques
E1086 Test Method for Atomic Emission Vacuum Spectrometric Analysis of Stainless Steel by Point-to-Plane Excitation Technique
G48 Test Methods for Pitting and Crevice Corrosion Resistance of Stainless Steels and Related Alloys by Use of Ferric Chloride Solution
Keywords
cold pressing; density; powder metallurgy (PM); prealloyed powder; sintering; stainless steel; structural (PM) components;
ICS Code
ICS Number Code 77.160 (Powder metallurgy)
DOI: 10.1520/B0853-02
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
