ASTM B831-93(1998)

    Standard Test Method for Shear Testing of Thin Aluminum Alloy Products


      Format Pages Price  
    PDF 3 $45.60   ADD TO CART


    1. Scope

    1.1 This test method covers single shear testing of thin wrought and cast aluminum alloy products to determine shear ultimate strengths.

    1.2 The values stated in inch-pound units are to be regarded as the standard. The SI values given in parentheses are provided for information only.

    1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B565 Test Method for Shear Testing of Aluminum and Aluminum-Alloy Rivets and Cold-Heading Wire and Rods

    B769 Test Method for Shear Testing of Aluminum Alloys

    E4 Practices for Force Verification of Testing Machines

    E6 Terminology Relating to Methods of Mechanical Testing


    ICS Code

    ICS Number Code 77.040.10 (Mechanical testing of metals); 77.150.10 (Aluminium products)

    UNSPSC Code

    UNSPSC Code 11172000(Aluminum based alloys)


    Referencing This Standard

    DOI: 10.1520/B0831-93R98

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM B831-93(1998), Standard Test Method for Shear Testing of Thin Aluminum Alloy Products, ASTM International, West Conshohocken, PA, 1998, www.astm.org

    Back to Top