1. Scope
1.1 This specification covers a standard basis for uniform testing and frequency to determine physical and electrical compliance for aluminum and copper drawing stock, and aluminum and copper conductors.
1.2 The values stated in inch-pound units are standard, with the exception of resistivity. The SI equivalents of inch-pound units may be approximate.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Other Documents
CanadianStandardsAss CAN/CSA-ISO 9000-1-94 Quality Management Quality Assurance Standards Part 1: Guidelines for Selection and Use
ANSI Standards
ANSI/ASQC Z1.4-1993 Sampling Procedures and Tables for Inspection by Attributes
Keywords
acceptable quality level (AQL); average outgoing quality (AOQ); control chart; lot; lower specification limit (LSL); process average; process control ratio (CPK); skip-lot inspection; statistical process control (SPC); upper specification limit (USL);
ICS Code
ICS Number Code 19.020 (Test conditions and procedures in general)
DOI: 10.1520/B0830-97R03
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
