SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|3||$46.80||  ADD TO CART|
1.1 This specification covers the requirements for four classes of machinable, high-density tungsten base metal produced by consolidating metal powder mixtures, the composition of which is mainly tungsten. This material specification may be used for bare parts or for parts that may be coated with other materials for protection against corrosion and abrasion.
1.2 Intended Use—Parts made from this material are intended for uses such as weights or counter-balances in static or dynamic balancing, high-speed rotating inertia members, radiation shielding, hypervelocity impact, and vibration-damping applications.
1.3 Special Applications—For particular applications, properties or requirements other than those specified in Sections 5, 6, and 7 of this specification may be important. These alloys may contain elements which make them magnetic. Where freedom from magnetic response is required, this should be specified in the purchase order. Class 4 is not available in a non-magnetic grade. For purposes of this specification, non-magnetic material is defined as material having a maximum magnetic permeability of 1.05 (see Test Method B 193). Also for special applications involving large sections, methods for determining internal quality, such as mechanical tests on specimens from these larger sections or suitable nondestructive tests may be applied. If required, these additional tests shall be specified in the purchase order.
1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A600 Specification for Tool Steel High Speed
B193 Test Method for Resistivity of Electrical Conductor Materials
B311 Test Method for Density of Powder Metallurgy (PM) Materials Containing Less Than Two Percent Porosity
D3951 Practice for Commercial Packaging
E3 Guide for Preparation of Metallographic Specimens
E8 Test Methods for Tension Testing of Metallic Materials
E18 Test Methods for Rockwell Hardness of Metallic Materials
E407 Practice for Microetching Metals and Alloys
Federal StandardFed. Std. No. 151 Metals, Test Methods Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://www.dodssp.daps.mil.
ICS Number Code 77.120.99 (Other non-ferrous metals and their alloys)
UNSPSC Code 12141747(Tungsten W)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM B777-07, Standard Specification for Tungsten Base, High-Density Metal, ASTM International, West Conshohocken, PA, 2007, www.astm.orgBack to Top