ASTM B744/B744M-05

    Historical Standard: ASTM B744/B744M-05 Standard Specification for Aluminum Alloy Sheet for Corrugated Aluminum Pipe

    SUPERSEDED (see Active link, below)


    Buy Standard (PDF)
    3 pages
    $44.40

    Active (view current version of standard)


    ASTM B744 / B744M

    1. Scope

    1.1 This specification covers aluminum alloy sheets used in the fabrication of corrugated aluminum pipe intended for use for storm water drainage, underdrains, culverts, and similar uses. The material is furnished corrugated in cut lengths, and uncorrugated in coils and cut lengths.

    1.2 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    American National Standards

    H35.2M Dimensional Tolerances for Aluminum Mill Products [Metric]

    ASTM Standards

    B209 Specification for Aluminum and Aluminum-Alloy Sheet and Plate

    B209M Specification for Aluminum and Aluminum-Alloy Sheet and Plate (Metric)

    B666/B666M Practice for Identification Marking of Aluminum and Magnesium Products


    ICS Code

    ICS Number Code 77.150.10 (Aluminium products)

    UNSPSC Code

    UNSPSC Code 40171507(Commercial aluminum pipe)


    DOI: 10.1520/B0744_B0744M-05

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top