ASTM B710-04

1.1 This specification covers alloys UNS N08330 and UNS N08332 in the form of welded pipe intended for heat-resisting applications and general-corrosive service.

1.2 The pipe covered is nominal pipe sizes up to and including size 12, with the nominal wall thicknesses given as Schedules 5S, 10S, 40S, and 80S. of Specification B 775 is based on Table A1 of ANSI B36.19 and gives the nominal dimension of these sizes. Table 3 of Specification B 775 lists the dimensional requirements of these sizes. Pipe having other dimensions may be furnished provided such pipe complies with all other requirements of this specification.

1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

ANSI Standard

Keywords

high-temperature alloy; welded pipe; Corrosive service applications--pipe (Ni/Ni alloy); High-temperature service applications--nickel (specifications); Nickel-iron alloy--specifications; Nickel-iron-chromium-silicon alloys--specifications; UNS N08330 (Ni-Fe-Cr alloy, RA 330); UNS N08332 (Ni-Fe-Cr-Si alloy, RA 330TX); Welded Ni/Ni alloy pipe--specifications

ICS Code

Citing ASTM Standards

[Back to Top]