SUPERSEDED (see Active link, below)
Active (view current version of standard)
1.1 This specification covers welded UNS N06625,* UNS N06219* and UNS N08825* pipe in the annealed condition (temper) for general corrosion applications.
1.2 This specification covers pipe sizes in schedules shown in the Permissible Variations in Outside Diameter and Wall Thickness for Welded Pipe table of Specification B 775.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 The following precautionary caveat pertains only to the test methods portion, Section , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B751 Specification for General Requirements for Nickel and Nickel Alloy Welded Tube
B775 Specification for General Requirements for Nickel and Nickel Alloy Welded Pipe
B880 Specification for General Requirements for Chemical Check Analysis Limits for Nickel, Nickel Alloys and Cobalt Alloys
ASME Boiler and Pressure Vessel CodeSectionIX Welding and Brazing Qualifications
ICS Number Code 77.120.40 (Nickel, chromium and their alloys)
UNSPSC Code 31311504(Inconel welded or brazed pipe assemblies)