1.1 This specification covers welded UNS N06625* and UNS N08825* pipe in the annealed condition (temper) for general corrosion applications.
1.2 This specification covers pipe sizes in schedules shown in Table 1.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 The following precautionary caveat pertains only to the test methods portions, Sections 7 and 13, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B751 Specification for General Requirements for Nickel and Nickel Alloy Welded Tube
B775 Specification for General Requirements for Nickel and Nickel Alloy Welded Pipe
B880 Specification for General Requirements for Chemical Check Analysis Limits for Nickel, Nickel Alloys and Cobalt Alloys
ASME Boiler and Pressure Vessel Code
SectionIX Welding and Brazing Qualifications
N06219; N06625; N08825; welded pipe; Corrosive service applications--pipe (Ni/Ni alloy); Nickel alloy pipe--specifications; Nickel-chromium alloys--specifications; Nickel-chromium-molybdenum-columbium alloys--specifications; Nickel-iron-chromium alloys--specifications; Nicrofer 6219Si; Udimet alloy; UNS N06219 (Ni-Cr-Mo-Si alloy, Nicrofer 6219Si); UNS N06625 (Ni-Cr alloy, Inconel 625); UNS N08825 (Ni-Fe-Cr alloy, Incoloy 825); Welded Ni/Ni alloy pipe--specifications;
ICS Number Code 77.120.40 (Nickel, chromium and their alloys)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]