ASTM B69-09

    Standard Specification for Rolled Zinc


      Format Pages Price  
    PDF 4 $45.60   ADD TO CART


    1. Scope

    1.1 This specification covers two types of commercial rolled zinc as described in 1.2. It should be understood that the specification is general. Any closer limitations on permissible variations shall be a matter of agreement between the supplier (manufacturer) and the purchaser.

    1.2 Rolled zinc is furnished in two types as follows:

    1.2.1 Type I -

    Coils or sheets cut from strip (ribbon) rolled zinc and

    1.2.2 Type II -

    Zinc plates such as boiler and hull plates produced by any rolling method.

    1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B899 Terminology Relating to Non-ferrous Metals and Alloys

    E8 Test Methods for Tension Testing of Metallic Materials

    E18 Test Methods for Rockwell Hardness of Metallic Materials

    E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

    E55 Practice for Sampling Wrought Nonferrous Metals and Alloys for Determination of Chemical Composition

    E60 Practice for Analysis of Metals, Ores, and Related Materials by Spectrophotometry

    E88 Practice for Sampling Nonferrous Metals and Alloys in Cast Form for Determination of Chemical Composition

    E384 Test Method for Knoop and Vickers Hardness of Materials

    E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)

    E536 Test Methods for Chemical Analysis of Zinc and Zinc Alloys

    E634 Practice for Sampling of Zinc and Zinc Alloys by Spark Atomic Emission Spectrometry

    ISO Standards

    ISO 3815-1 Zinc and zinc alloys--Part 1: Analysis of solid samples by optical emission spectrometry

    ISO 3815-2 Zinc and zinc alloys--Part 2: Analysis by inductively coupled plasma optical emission spectrometry


    ICS Code

    ICS Number Code 77.120.60 (Lead, zinc, tin and their alloys)

    UNSPSC Code

    UNSPSC Code 30262800(Zinc bars and sheets)


    Referencing This Standard

    DOI: 10.1520/B0069-09

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM B69-09, Standard Specification for Rolled Zinc, ASTM International, West Conshohocken, PA, 2009, www.astm.org

    Back to Top