ASTM B682-01

    Standard Specification for Standard Metric Sizes of Electrical Conductors

    SUPERSEDED (see Active link, below)

      Format Pages Price  
    PDF 4 $44.40   ADD TO CART

    1. Scope

    1.1 This specification prescribes the recommended standard metric sizes of solid round electrical conductors.

    1.2 This specification prescribes the recommended standard metric size designations of stranded electrical conductors (see Explanatory Note 1).

    Note 2--Physical properties, construction requirements, and manufacturing tolerances for specific products should be included in individual product specifications developed in accordance with appropriate sizes in this specification.

    1.3 The values stated in inch-pound or SI units are to be regarded separately as standard. Each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. For conductor sizes designated by AWG or kcmil, the requirements in SI units have been numerically converted from corresponding values, stated or derived, in inch-pound units. For conductor sizes designated by SI units only, the requirements are stated or derived in SI units.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

    F205 Test Method for Measuring Diameter of Fine Wire by Weighing

    IEC Standards

    IEC228 Nominal Cross-Sectional Areas and Composition of Conductors of Insulated Cables

    ISO Standards

    ISOR388 Metric Series for Basic Thickness of Sheet and Diameters of Wire

    ICS Code

    ICS Number Code 29.050 (Superconductivity and conducting materials)

    UNSPSC Code

    UNSPSC Code 26121500(Electrical wire)

    DOI: 10.1520/B0682-01

    ASTM International is a member of CrossRef.

    Citing ASTM Standards
    Back to Top