1.1 This practice establishes the physical item marking requirements for identification purposes for aluminum and magnesium products. Package marking for shipment and inspection acceptance is not within the scope of this standard.
1.2 The values stated in either inch-pound units or SI are to be regarded separately as standard. The SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems will result in nonconformance with the practice.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B361 Specification for Factory-Made Wrought Aluminum and Aluminum-Alloy Welding Fittings
B404/B404M Specification for Aluminum and Aluminum-Alloy Seamless Condenser and Heat-Exchanger Tubes with Integral Fins
B547/B547M Specification for Aluminum and Aluminum-Alloy Formed and Arc-Welded Round Tube
B881 Terminology Relating to Aluminum- and Magnesium-Alloy Products
H35.1/H35.1(M) Alloy and Temper Designation Systems for Aluminum Available from Aluminum Association, Inc., 1525 Wilson Blvd., Suite 600, Arlington, VA 22209, http://www.aluminum.org.
MIL-STD-409 Alloy Nomenclature and Temper Designation System for Magnesium Base Alloys Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://www.dodssp.daps.mil.
aluminum products; identification markings; magnesium products; Aluminum alloys; Aluminum alloys (castings); Aluminum castings; Identification labels/marking; Magnesium alloys; Marking; Wrought aluminum products;
ICS Number Code 77.150.10 (Aluminium products); 77.150.99 (Other products of non-ferrous metals)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]