ASTM B654-03

    Historical Standard: ASTM B654-03 Standard Specification for Niobium-Hafnium Alloy Foil, Sheet, Strip, and Plate

    SUPERSEDED (see Active link, below)


    Buy Standard (PDF)
    5 pages
    $50.40

    Active (view current version of standard)


    1. Scope

    1.1 This specification covers niobium-hafnium-titanium alloy foil, sheet, strip, and plate.

    Note 1—Committee B10 has adopted "niobium" as the designation for Element 41, formerly named "columbium."

    1.2 The material covered by this specification is R04295, niobium-base alloy containing approximately 10 % hafnium and 1 % titanium.

    1.3 Except for dimensional tolerances in Table 4, the values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

    1.4 The following safety hazards caveat pertains only to the test methods portion, Section , of this specification: This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    ICS Code

    ICS Number Code 77.150.99 (Other products of non-ferrous metals)

    UNSPSC Code

    UNSPSC Code 30102202(Non ferrous plate)


    DOI: 10.1520/B0654-03

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top