1. Scope
1.1 This test method covers the determination of indentation hardness of aluminum alloys using a Barcol Impressor, Model No. 934-1.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
Note 1--Another model, No. 935, is for use on plastics but is not included in this test method and should not be used for aluminum alloys.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
E6 Terminology Relating to Methods of Mechanical Testing
E10 Test Method for Brinell Hardness of Metallic Materials
E18 Test Methods for Rockwell Hardness of Metallic Materials
E177 Practice for Use of the Terms Precision and Bias in ASTM Test Methods
E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
Keywords
aluminum alloys-indentation hardness; Barcol impressor test; hardness (indentation)-aluminum alloys; hardness tests-Barcol Impressor; indentation hardness-Al-alloys, by Barcol impressor, test;
ICS Code
ICS Number Code 77.120.10 (Aluminium and aluminium alloys)
DOI: 10.1520/B0648-78R00
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
