ASTM B646-04

    Standard Practice for Fracture Toughness Testing of Aluminum Alloys


      Format Pages Price  
    PDF 7 $51.60   ADD TO CART


    1. Scope

    1.1 Fracture toughness is a key property for a number of aluminum alloys utilized in aerospace and process industries. Fracture toughness testing is often required for supplier qualification, quality control, and material release purposes. The purpose of this practice is to provide uniform test procedures for the industry, pointing out which current standards are utilized in specific cases, and providing guidelines where no standards exist. This practice provides guidance for testing (a) thin products, of thicknesses equivalent to sheet that is 0.249 in. (6.32 mm), (b) intermediate thicknesses of plate, forgings, and extrusions, too thin for valid plane-strain fracture toughness testing but too thick for treatment as sheet, for example, over 0.249 in. (6.32 mm) and up to 1 to 2 in. (25 to 50 mm), dependent upon toughness level, and (c) relatively thick products where Test Method E 399 is applicable.

    1.2 This practice addresses both direct measurements of fracture toughness and screening tests, the latter recognizing the complexity and expense of making formal fracture toughness measurements on great quantities of production lots.

    1.3 The values stated in inch-pound units are to be regarded as the standard. The values in SI units given in parenthesis are provided for information purposes only.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B557 Test Methods for Tension Testing Wrought and Cast Aluminum- and Magnesium-Alloy Products

    B557M Test Methods for Tension Testing Wrought and Cast Aluminum- and Magnesium-Alloy Products (Metric)

    B645 Practice for Linear-Elastic Plane-Strain Fracture Toughness Testing of Aluminum Alloys

    E399 Test Method for Linear-Elastic Plane-Strain Fracture Toughness K Ic of Metallic Materials

    E561 Test Method for K-R Curve Determination

    E1304 Test Method for Plane-Strain (Chevron-Notch) Fracture Toughness of Metallic Materials

    E1823 Terminology Relating to Fatigue and Fracture Testing


    UNSPSC Code

    UNSPSC Code 11172000(Aluminum based alloys)


    Referencing This Standard

    DOI: 10.1520/B0646-04

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM B646-04, Standard Practice for Fracture Toughness Testing of Aluminum Alloys, ASTM International, West Conshohocken, PA, 2004, www.astm.org

    Back to Top