ASTM B595-95e1

    Standard Specification for Sintered Aluminum Structural Parts


      Format Pages Price  
    PDF 3 $45.60   ADD TO CART


    1. Scope

    1.1 This specification covers sintered aluminum structural parts made primarily from aluminum powders to which controlled amounts of master alloys or elemental copper, magnesium, and silicon have been added by blending.

    1.2 This specification covers the following variables:

    1.2.1 Composition— Depending upon levels of copper, magnesium, and silicon content, two grades, and

    1.2.2 Density—Type.

    1.3 Parts ordered to this specification will be in one of the following conditions:

    1.3.1 As-sintered,

    1.3.2 As-repressed for additional density, or

    1.3.3 All other conditions plus heat treated.

    1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B243 Terminology of Powder Metallurgy

    B962 Test Methods for Density of Compacted or Sintered Powder Metallurgy (PM) Products Using Archimedes Principle

    B963 Test Methods for Oil Content, Oil-Impregnation Efficiency, and Interconnected Porosity of Sintered Powder Metallurgy (PM) Products Using Archimedes Principle

    E8 Test Methods for Tension Testing of Metallic Materials


    UNSPSC Code

    UNSPSC Code 31420000(Sintered parts); 11101705(Aluminum)


    Referencing This Standard

    DOI: 10.1520/B0595-95E01

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM B595-95e1, Standard Specification for Sintered Aluminum Structural Parts, ASTM International, West Conshohocken, PA, 1995, www.astm.org

    Back to Top