SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|5||$52.80||  ADD TO CART|
1.1 This test method describes procedures for the determination of the reversed or repeated bending fatigue properties of copper alloy flat-sheet or strip-spring materials by fixed cantilever, constant amplitude of displacement-type testing machines. This method is limited to flat stock ranging in thickness from 0.005 to 0.062 in. (0.13 to 1.57 mm), to a fatigue-life range of 105 to 108 cycles, and to conditions where no significant change in stress-strain relations occurs during the test.
Note 1—This implies that the load-deflection characteristics of the material do not change as a function of the number of cycles within the precision of measurement. There is no significant cyclic hardening or softening.
1.2 The values stated in inch-pound units are to be regarded as the standard. SI values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B846 Terminology for Copper and Copper Alloys
B950 Guide for Editorial Procedures and Form of Product Specifications for Copper and Copper Alloys
E206 Definitions of Terms Relating to Fatigue Testing and the Statistical Analysis of Fatigue Data; Replaced by E 1150
E468 Practice for Presentation of Constant Amplitude Fatigue Test Results for Metallic Materials
ICS Number Code 77.150.30 (Copper products)
UNSPSC Code 31161900(Springs); 41114608(Fatigue testers)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM B593-96(2003), Standard Test Method for Bending Fatigue Testing for Copper-Alloy Spring Materials, ASTM International, West Conshohocken, PA, 2003, www.astm.orgBack to Top