1.1 This specification covers refined palladium as sponge, cast bar, and wrought forms (Note 1) in one grade as follows:
1.1.1 Grade 99.95 (UNS PO3995)—Palladium having a purity of 99.95 %.
Note 1—Other forms of unfabricated palladium of commerce are not to be excluded under this specification.
Note 2—For the purposes of determining conformance with this specification, an observed value obtained from analysis shall be rounded to the nearest unit in the last right hand place of figures used in expressing the limiting value, in accordance with the rounding method of Practice E 29.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
palladium; refined palladium; sponge;
ICS Number Code 77.120.99 (Other non-ferrous metals and their alloys)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]