ASTM B582-97

    Standard Specification for Nickel-Chromium-Iron-Molybdenum-Copper Alloy Plate, Sheet, and Strip


      Format Pages Price  
    PDF 5 $51.60   ADD TO CART


    1. Scope

    1.1 The specification covers plate, sheet, and strip of nickel-chromium-iron-molybdenum-copper alloys (UNS N06007, N06975, N06985, and N06030)* as shown in Table 1, for use in general corrosive service.

    1.2 The following products are covered under this specification:

    1.2.1 Sheet and Strip -Hot or cold rolled, solution annealed, and descaled unless solution anneal is performed in an atmosphere yielding a bright finish.

    1.2.2 Plate -Hot or cold rolled, solution annealed, and descaled.

    1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B906 Specification for General Requirements for Flat-Rolled Nickel and Nickel Alloys Plate, Sheet, and Strip


    ICS Code

    ICS Number Code 77.150.40 (Nickel and chromium products)

    UNSPSC Code

    UNSPSC Code


    Referencing This Standard

    DOI: 10.1520/B0582-97

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM B582-97, Standard Specification for Nickel-Chromium-Iron-Molybdenum-Copper Alloy Plate, Sheet, and Strip, ASTM International, West Conshohocken, PA, 1997, www.astm.org

    Back to Top