ASTM B582-02

    Historical Standard: ASTM B582-02 Standard Specification for Nickel-Chromium-Iron-Molybdenum-Copper Alloy Plate, Sheet, and Strip

    SUPERSEDED (see Active link, below)


    Buy Standard (PDF)
    5 pages
    $50.40

    Active (view current version of standard)


    ASTM B582

    1. Scope

    1.1 The specification covers plate, sheet, and strip of nickel-chromium-iron-molybdenum-copper alloys (UNS N06007, N06975, N06985, and N06030)* as shown in , for use in general corrosive service.

    1.2 The following products are covered under this specification:

    1.2.1 Sheet and Strip—Hot or cold rolled, solution annealed, and descaled unless solution anneal is performed in an atmosphere yielding a bright finish.

    1.2.2 Plate—Hot or cold rolled, solution annealed, and descaled.

    1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

    1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B906 Specification for General Requirements for Flat-Rolled Nickel and Nickel Alloys Plate, Sheet, and Strip


    ICS Code

    ICS Number Code 77.150.40 (Nickel and chromium products)

    UNSPSC Code

    UNSPSC Code


    DOI: 10.1520/B0582-02

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top