ASTM B573-06

    Standard Specification for Nickel-Molybdenum-Chromium-Iron Alloys (UNS N10003, N10242)* Rod

    SUPERSEDED (see Active link, below)


      Format Pages Price  
    PDF 3 $44.40   ADD TO CART


    1. Scope

    1.1 This specification covers nickel-molybdenum-chromium-iron alloys (UNS N10003 and UNS N10242)* rod for use in general corrosive service.

    1.2 The following products are covered under this specification:

    1.2.1 Rods 5/16to 3/4 in. (7.94 to 19.05 mm) excl in diameter, hot or cold finished, annealed, and pickled or mechanically descaled.

    1.2.2 Rods 3/4to 31/2 in. (19.05 to 88.9 mm) incl in diameter, hot or cold finished, annealed, ground, or turned.

    1.3 The values stated in inch-pound units are to be regarded as the standard.

    This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Materials Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B880 Specification for General Requirements for Chemical Check Analysis Limits for Nickel, Nickel Alloys and Cobalt Alloys

    E8 Test Methods for Tension Testing of Metallic Materials

    E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

    E1473 Test Methods for Chemical Analysis of Nickel, Cobalt, and High-Temperature Alloys


    UNSPSC Code

    UNSPSC Code 30102402(Non ferrous alloy rods)


    DOI: 10.1520/B0573-06

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top