SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|5||$52.80||  ADD TO CART|
1.1 This specification covers three grades of zirconium and zirconium alloy bar and wire.
1.2 Unless a single unit is used, for example corrosion mass gain in mg/dm2, the values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore each system must be used independently of the other. SI values cannot be mixed with inch-pound values.
1.3 The following precautionary caveat pertains only to the test methods portions of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
E8 Test Methods for Tension Testing of Metallic Materials
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
ICS Number Code 77.150.99 (Other products of non-ferrous metals)
UNSPSC Code 30266002(Non ferrous alloy bar)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM B550 / B550M-07, Standard Specification for Zirconium and Zirconium Alloy Bar and Wire, ASTM International, West Conshohocken, PA, 2007, www.astm.orgBack to Top