1.1 This specification covers wrought heat-resisting alloy UNS N08330 in the form of billets and bars only for reforging.
1.2 The values stated in inch-pound units are to be regarded as the standard. The metric equivalent of the inch-pound units may be approximate.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B880 Specification for General Requirements for Chemical Check Analysis Limits for Nickel, Nickel Alloys and Cobalt Alloys
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
E1473 Test Methods for Chemical Analysis of Nickel, Cobalt, and High-Temperature Alloys
bar; billet; high-temperature alloy; Billets--Ni/Ni alloy; High-temperature service applications--nickel (specifications); Nickel alloy rod/bar/wire--specifications; Nickel-chromium alloys--specifications; Nickel-chromium-silicon alloys--specifications; UNS N08330 (Ni-Fe-Cr alloy, RA 330)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]