ASTM B502-10

    Standard Specification for Aluminum-Clad Steel Core Wire for Use in Overhead Electrical Aluminum Conductors


      Format Pages Price  
    PDF 3 $45.60   ADD TO CART


    1. Scope

    1.1 This specification covers round, aluminum-clad steel core wire with two designations of tensile strengths, AW2 (Normal Strength) and AW3 (High Strength).

    1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

    1.2.1 For conductor sizes designated by AWG, the requirements in SI units have been numerically converted from corresponding values stated or derived in inch-pound units. For conductor sizes designated by SI units only, the requirements are stated or derived in SI units.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B193 Test Method for Resistivity of Electrical Conductor Materials

    E8 Test Methods for Tension Testing of Metallic Materials


    ICS Code

    ICS Number Code 29.060.10 (Wires)

    UNSPSC Code

    UNSPSC Code 26121500(Electrical wire)


    Referencing This Standard

    DOI: 10.1520/B0502-10

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM B502-10, Standard Specification for Aluminum-Clad Steel Core Wire for Use in Overhead Electrical Aluminum Conductors, ASTM International, West Conshohocken, PA, 2010, www.astm.org

    Back to Top